ADC is The Newest Representative of WinCast Expert in The US
Permanent Die Casting
- CAD Geometry
- Temperature Field
- Filling Velocity
- Stress
- Deformation
- Hot Spot
- Tensile Strength
- Elongation
- Yield Strength
- Defects (ASTM)
Sand Casting
- The total riser and gating system, filter and core are the part of the model
- Precise physical data for exothermic materials are available
- Graphite expansion and precise defect prediction are typical requirements
- Validation with experiments is fundamental for good simulation results
High Pressure Die Casting
- CAD Data
- FEM Model
- Mold Filling
- Solidification
- Residual Stress
- Cycle Calculation
Low Pressure Die Casting
- Process Optimization
- Mechanical Properties
- Cooling Calculation
- Defect Calculation
- Pressure-time Input
- Dendrite Arm Spacing
Investment Casting
Precise geometry with high level of detail is the reason for real success.
Optimized riser and gating system leads to a minimal deformed part. Simulation of temperature, solidification, stress and deformation are the keys to reach optimum.
Optimized riser and gating system leads to a minimal deformed part. Simulation of temperature, solidification, stress and deformation are the keys to reach optimum.
Continuous Casting
The thermal and mechanical equations are coupled. Thus the material flow and the shrinkage of the billet can be determined as well as the gap formation and gap dependent heat transfer.
- Primary and secondary cooling
- Material and heat transport
- Pull (and push) conditions
- Contact between strand and graphite chill
- Contact between graphite and copper chill
- Heat transport within cooling lines
Heat Treatment
The changing residual stresses while heat treatment can be calculated in order to optimize the oven curve to reduce deformation.
Stress/Distortion/Lifetime
High differences in temperature during a high pressure die casting cycle and enormous pressure peaks are the reasons for local cracking in the die and reduce the lifetime significantly.
Evaluation of Mechanical Properties
Complex thin-walled aluminum casting.
Stress and Crack Investigation
Fast. Precise. Easy to Handle.
If you are interested in WinCast Expert or need simulations as a service please click the link below and fill out our contact form.